![]() A solid bond can be achieved when you do the work right. Some people have used different adhesives that have held wood to fiberglass for over 3 years. This will make sure the bond is very secure and holding fast. You want to let it completely dry before removing the screws. You may need to drill some temporary screws into place to hold the wood in place while the adhesive dries. Wood is porous already so you do not have to worry so much about that surface but make sure it is clean. The goal is to give the adhesive something to hold onto, not damage the fiberglass. The instructions on the different products will guide you through the prep work and you do not have to press too hard when roughing up the fiberglass. The bond will depend on how well you do the prep work and how clean the surface is. Not all adhesives are the same and even though it is made by a top brand, the hold may not be as expected. ![]() You need to give the adhesive something to hold onto to make sure the bond is tight and will last a long time.Īlso, the hold will depend on the quality of the adhesive. The bond will depend on how well you scar the surface of the fiberglass. It is highly recommended to make the bond permanent. Another 3M product that may work should be the VHB tape. There are some top adhesives made for this purpose and a third choice would be 3m’s 4200 Fast Cure and it can be used on the rough side of the fiberglass surface. Liquid Nails may also not work that well and may need bolts to help it hold the wood in place. ![]() Just any glue will not do and even super or crazy glue may have difficulty bonding the two products together. It will if you use the right type of adhesive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |